SC-01K Prop Cowl Kit

The SC-01K Prop Cowl is mounted above the propeller of a trolling motor to stop prop splash and noise. Essential for e-cruising in your small boat. Fits both 1 and 1-1/8 inch shafts.

Trolling motors are designed to push or turn big bass boats at slow speed. But when used for e-cruising at 3 MPH and faster, air is sucked down the back of the round straight shaft where it is pulled into the propeller. This prop aeration not only reduces the power of the motor, but also creates a lot of splash and noise - as loud as a gasoline motor. The eCanoe solution is a fitted cowl for the shaft just above the prop. This cowl strips the column of air off the motor shaft before it can get to the prop. Additionally, prop splash is stopped and actually turned into additional thrust. With the eCanoe SC-01 Cowl, the prop can be run one or two inches under the water surface without aeration, noise, lost power, or unwanted splash. The SC-01K Cowl Kit contains one black UV-Resistant 8in x 10in ABS cowl and bracket assembly, two all-stainless band clamps, one adhesive neoprene shim, one sanding cloth and full instructions. With a 3-year Limited Warranty in normal boating use, the SC-01 may outlast more than one trolling motor. Fits both 1 inch (2.54cm) and 1-1/8 inch (2.86cm) shafts. See the fully illustrated instructions at www.ecanoe.org. Made in the USA.